TM-11-6625-922-15

• OPERATOR, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOL LISTS
• WARNING
• TABLE OF CONTENTS
• TABLE OF CONTENTS
• Figure 1-1. Measuring Set, Envelope Delay Distortion TS-2669/GCM.
• CHAPTER 1 INTRODUCTION
• Technical Characteristics
• CHAPTER 2 INSTALLATION
• Figure 2-1. Packaging diagram
• Figure 2-2. Internal power supply connections.
• CHAPTER 3 OPERATING INSTRUCTIONS
• Controls, Indicators, and Jacks
• Modes of Operation
• Figure 3-1. Operator's controls and indicators.
• Figure 3-2. Rear panel, location of connectors.
• Figure 3-4. Connections for end-to-end with return reference
• Figure 3-5. Connection for loop mode
• Figure 3-5. Connection for loop mode.
• End-to-End Operating Mode
• End-to-End with Return Reference Mode
• CHAPTER 4 ORGANIZATIONAL MAINTENANCE
• Organizational Quarterly Preventive Maintenance Checks and Services Chart Sequence
• Organizational Quarterly Preventive Maintenance Checks and Services Chart Sequence
• Section II. TROUBLESHOOTING, REPAIR, AND ADJUSTMENT
• Repair Procedures
• CHAPTER 5 FUNCTIONING OF EQUIPMENT
• Figure 5-2. Basic delay measuring system.
• Description of Logic
• Figure 5-3. Simplified block diagram.
• Integrated Circuits
• Figure 5-5. Frequency counter display logic.
• Circuit Descriptions
• Figure 5-6(1). Pin connections of integrated circuits (part 1 of 2).
• Figure 5-6(2). Pin connections of integrated circuits (part 2 of 2).
• Figure 5-8. Integrated circuit packages, pin numbers.
• Analog Frequency Output
• Frequency Counter-Display
• Frequency Counter-Display-CONT.
• CHAPTER 6 GENERAL SUPPORT MAINTENANCE
• Section II. REPAIR AND TESTING
• Calibration
• Final Test Procedures
• Final Test Procedures-CONT.
• Figure 6-1. Test setup.
• OCHAPTER 7 DEPOT OVERHAUL STANDARDS
• CHAPTER 8 SHIPMENT, LIMITED STORAGE, AND DEMOLITION TO PREVENT ENEMY USE
• CHAPTER 9 ILLUSTRATIONS
• APPENDIX A REFERENCES
• APPENDIX B BASIC ISSUE ITEMS
• SECTION II BASIC ISSUE ITEMS
• APPENDIX C MAINTENANCE ALLOCATION
• Section II.
• SECTION III
• APPENDIX D ORGANIZATIONAL, DS, GS, AND DEPOT REPAIR PARTS
• Location of Repair Parts
• Federal Supply Codes
• SECTION II PRESCRIBED LOAD ALLOWANCE
• SECTION III REPAIR PARTS FOR ORGANIZATIONAL MAINTENANCE
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION II REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION IV. REPAIR PARTS FOR DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE-CONT.
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION V. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VI. INDEX-FEDERAL STOCK NUMBER CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER-CONT.
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER (CONTINUED)
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER (CONTINUED)
• SECTION VII. INDEX-REFERENCE DESIGNATION CROSS REFERENCE TO INDEX NUMBER (CONTINUED)
• Figure 9-4. 2-MHz oscillator (A4), C-4696, location of components.
• Figure 9-5. Variable-frequency oscillator (A2), D-4710, schematic diagram.
• Figure 9-7. Sweep drive (A16), C-4707, schematic diagram.
• Figure 9-8. Sweep drive (A16 ), C-4707, location of components.
• Figure 9-9. 2-MHz modulator mixer (A14), C-4705, schematic diagram.
• Figure 9-10. 2-MHz modulator mixer (A14), C-4705, location of component.
• Figure 9-11. 200-kHz modulator mixer (A15), C-4706, schematic diagram.
• Figure 9-12. 200-kHz modulator mixer (A15), C-4706, location of components.
• Figure 9-13. Low-pass active filters (A7, A13), C-4699-1, C-4699-2, schematic diagram.
• Figure 9-14. Low-pass active filters (A7), C-4699-1, location of components.
• Figure 9-15. Lowpass active filter (A13), C-4699-2, location of components.
• Figure 9-16. Input amplifier and demodulator (A6), C-4698, schematic diagram.
• Figure 9-17. Input amplifier and demodulator (A6), C-4698, location of components.
• Figure 9-18. Output amplifier and meter amplifier (A12), C-4704, schematic diagram.
• Figure 9-19. Output amplifier and meter amplifier (A12), C-4704, location of components
• Figure 9-21. Analog output (A3), C-4801, location of components
• Figure 9-23. Delay output (A8), C-4700, location of components
• Figure 9-24. Countdown logic (A10), C-4702, schematic diagram
• Figure 9-25. Countdown logic (A10), C-4702, location of components
• Figure 9-26. Time delay logic (A9), C-4701, schematic diagram
• Figure 9-27. Time delay logic (A9), C-4701, location of components
• Figure 9-28. Frequency counter/display (A1), D-4637, schematic diagram
• Figure 9-29(1). Frequency counter/display (A1), D-4637, location of components (part 1 of 2).
• Figure 9-29 (2). Frequency counter-display (A1), D-4637, location of components (part 2 of 2).
• Figure 9-30. +12- and -12-volt regulators (A11), C-4703, schematic diagram.
• Figure 9-31. +12- and -12-volt regulators (A11), C-4703, location of components
• Figure 9-32. +5-volt regulator (A5), C-4697, schematic diagram
• Figure 9-33. +5-volt (A5), C-4697, location of components
• Figure 9-34(1). Location of assemblies (part 1 of 2)
• Figure 9-34(2). Location of assemblies (part 2 of 2)
• Figure 9-35. Signal waveforms
• Figure 9-36(2). Assembly drawing (part 2 of 4).
• Figure 9-36(3). Assembly drawing (part 3 of 4).
• Figure 9-43. Extender board assembly (A19), C-4695
• Figure 9-39. Receive impedance selector and attenuator (A18), C-4714, schematic diagram
• Figure 9-41. Meter modulation adjust (A20), B-4806, Schematic diagram
• Figure 9-48. Extender board assembly (A19), C-4695.
• Figure 9-1. Complete schematic diagram (transmit).
• Figure 5-4. Delay and frequency generation logic.
• Figure 9-2. Complete schematic diagram (receive).
• Figure 9-3. 2-MHz oscillator (A4), C-4696, schematic diagram
• Figure 9-6. Variable-frequency oscillator (A2), D-4710, location of components.
• Figure 9-20. Analog output (AS), C-4801, schematic diagram.
• Figure 9-22. Delay output (A8), C-4700, schematic diagram.
• Figure 9-6(1). Assembly drawing (part 1 of 4).
• Figure 9-36(4). Assembly drawing (part 4 of 4).
• The Metric System and Equivalents
• TM-11-6625-922-15
• BLANK PAGE
• Distribution
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS

Privacy Statement - Press Release - Copyright Information. - Contact Us