APPENDIX D ORGANIZATIONAL, DS, GS, AND DEPOT REPAIR PARTS

TM 11-6625-922-15

APPENDIX D

ORGANIZATIONAL, DS, GS, AND DEPOT REPAIR PARTS

Section I. INTRODUCTION

index of reference designations and/or item numbers to

D-1. Scope

index numbers.

This appendix contains a list of repair parts required for

the performance of organizational maintenance and a

list covering the corresponding requirements for general

D-3. Explanation of Columns

support and depot maintenance for Measuring Set,

An explanation of the columns is given below.

Envelope Delay Distortion TS-2669/GCM.

a. Source, Maintenance, and Recoverability Codes

Notes:

(SMR) and Index Numbers Column. The first line in this

1. No parts authorized for stockage at direct support.

column lists the applicable SMR codes for the part.

2. No special tools, test, and support equipment are

Listed in ascending order directly below the SMR codes

required.

is the index number assigned to the repair part.

(1) Source code (S). The selection status

D-2. General

and source for the listed item is noted here. Source

The repair parts list is divided into the following sections:

codes and their explanations are as follows:

a. Prescribed Load Allowance (PLA), Section II.

Code

Explanation

The PLA is a consolidated listing of repair parts

P --- Applies to repair parts that are stocked in or

allocated for initial stockage at the organizational

supplied from the GSA/DSA, or Army

maintenance category. This is a mandatory minimum

supply system, and authorized for use at

stockage allowance.

indicated maintenance categories.

b. Repair Parts for Organizational Maintenance,

M --- Applies to repair parts -that are not procured

Section III. Repair parts authorized for organizational

or stocked but are to be manufactured at

maintenance are included in this section.

indicated maintenance categories.

c. Repair Parts for Direct Support, General

A --- Applies to assemblies that are not procured or

Support, and Depot Maintenance, Section IV. Repair

stocked as such but are made up of two or

parts authorized for general support and depot

more units, each of which carries an

maintenance are included in this section. No parts

individual stock number and description

authorized for stockage at direct support.

and is procured and stocked and can be

assembled

units

indicated

Note.

All indexes noted below are cross

maintenance categories.

referenced to index numbers. The index numbers

X1--- Applies to repair parts that are not procured or

appear in ascending sequence in column 1 of the repair

stocked, the requirement for which will be

parts list (para D3a).

The index number for the

supplied by the use of next higher

particular item will be the same for the item in all

assembly or component.

sections of this appendix.

X2--- Applies to repair parts that are not stocked.

d. Federal Stock Number Cross Reference to

The

indicated

maintenance