EQUIPMENT CONTAINER ASSEMBLY.

TM 3-1040-279-12&P

4-16 EQUIPMENT CONTAINER ASSEMBLY.

This task covers removal and installation of equipment container and replacement of:

Fog Oil Supply Hose Assembly

Solenoid Assembly (P. 4-70)

(P. 4-81)

Pressure Switch Bracket Assembly

Fog Oil Pressure Hose Assembly

(P. 4-72)

(P. 4-82)

Terminal Bracket Assembly (P. 4-74)

Air Hose Assembly (P. 4-83)

Ignition Coil (P. 4-76)

Purge Air Hose Assembly (P. 4-84)

Relay K101 (P. 4-78)

Air Supply Hose Assembly (P. 4-86)

Cable Assembly 5 J2 (P. 4-79)

Start Air Hose Assembly (P. 4-88)

Ignition Cab/e Assembly (P. 4-80)

INITIAL SETUP

Materials

Sealing compound (Item 11 A, App E)

Tools

General Mechanic's Automotive Tool Kit

General Safety Instructions

SC 5180-CL-N26

Before performing any maintenance procedures

be sure circuit breaker CB1 is in the OFF

Automotive Shop Equipment

position.

SC 4910-95-CL-A74:

Before performing any maintenance procedures

Torque wrench

on air lines remove pressure from lines by

Equipment Condition

opening drain valve on compressor.

M1059 vehicles - Inboard armor shield lowered

Fog oil is very slippery, clean up all spills

and smoke generator removed from vehicle

immediately to prevent injury to personnel.

mount (TM 9-2350-261-20-1).

NOTE

Alternate equipment container panel has three slots and requires only six

screws and six lockwashers. If your equipment container assembly has

alternate equipment container panel, removal and installation procedures are

as follows:

ALTERNATE STYLE

OLD STYLE

Alternate Equipment Container Panel.

REMOVAL

Remove three top screws and lock washers and loosen three bottom screws and lock washers.

Remove panel from equipment container.

INSTALLATION

Position panel under three bottom lock washers and place on equipment container.

Secure with three top screws and lock washers and tighten three bottom screws.

4-67

Change 4