Air Supply Hose Assembly. - TM-3-1040-279-12-P0150

TM 3-1040-279-12&P

4-16 EQUIPMENT CONTAINER ASSEMBLY (CONT).

l. Air Supply Hose Assembly.

REMOVAL

1. Remove equipment container (P. 4-68).

2. Loosen two screws (1) securing sides of cover assembly (2). Remove two screws (3), lock washers

(4), and washers (5) securing top of cover assembly and open cover assembly.

3. Remove eight screws (6) and washers (7) securing right equipment container panel (8).

4. Remove eight screws (9) and washers (10) securing left equipment container panel (11).

5. Remove four screws (12), flat washers (13), and lock washers (14) securing pressure switch

bracket assembly (15).

6. Remove four screws (16), washers (17) and lock washers (18) securing terminal bracket

assembly (19).

7. Disconnect air supply hose (20) from solenoid assembly (21).

8. Disconnect air supply hose (20) from quick disconnect coupling (22) on cover assembly (2).

9. Remove air supply hose (20) from equipment container (23).

INSTALLATION

1. Connect air supply hose (20) to quick disconnect coupling (22) in cover assembly (2).

2. Run air supply hose (20) through equipment container (23) and connect air supply hose (20)

to solenoid assembly (21).

3. Position pressure switch bracket assembly (15) and secure with four screws (12), flat washers

(13) and lock washers (14).

4. Position equipment container panel (11) and secure with four screws (9) and washer (10).

5. Position terminal bracket assembly (19) and secure with eight screws (16), washers (17) and lock

washers (18).

6. Position equipment container panel (8) and secure with four screws (6) and washers (7).

NOTE

Insure spring guard on air supply hose is

positioned within 1 inch of hose fitting at

cover assembly.

7. Slowly close cover assembly (2). Position hoses in equipment container while closing cover so

that hoses do not become kinked or pinched. Secure cover assembly with screws (1 and 2), lock

washers (4), and washers (5).

8. Install equipment container (P. 4-68).

Change 2