Ignition Cable Assembly.

TM 3-1040-279-12&P

4-16 EQUIPMENT CONTAINER ASSEMBLY (CONT).

g. Ignition Cable Assembly.

REMOVAL

1. Loosen two screws (1) securing sides of cover assembly (2). Remove two screws (3), lockwashers

(4), and washers (5) securing top of cover assembly and open cover assembly.

2. Remove ignition cable (6) from ignition coil (7).

CAUTION

Ignition cable contains a ceramic insulator. Take care when removing cable

from igniter or insulator will break. Pull cable straight out from igniter.

3. Remove ignition cable (6) from ignitor (8).

4. Remove ignition cable (6) from equipment container (9).

INSTALLATION

1. Install ignition cable (6) through equipment container (9).

CAUTION

Ignition cable contains a ceramic insulator. Take care when installing cable on

ignitor or insulator will break. Insert cable straight in on ignitor.

2. Install ignition cable (6) on ignitor (8).

3. Install ignition cable (6) on ignition coil (7).

4. Slowly close cover assembly (2). Position hoses in equipment container while closing cover so that

hoses do not become kinked or pinched. Secure cover assembly with screws (1 and 3), lockwashers

(4), and washers (5).

Change 3

4-80