CHAPTER 3 GENERAL SUPPORT MAINTENANCE

TM 11-5995-208-24&P-1

CHAPTER 3

GENERAL SUPPORT MAINTENANCE

Subject

Page

Common Tools and Equipment . . . . . . . . . . . . . . . . . . . . . . . . . .

Connector UG-1870A/U Replacement . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3

General (Performance Standards) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-32

General (General Support Maintenance Procedures) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2

General (General Support Troubleshooting) . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . 3-1

Insulation Breakdown/Leakage Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-32

Repair Parts . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1

Resistance Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-39

Special Tools, TMDE, and Support Equipment . . . . . . .. . . . . . . . . . . . . . . . . . . . . . 3-1

Section I REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC

EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

COMMON TOOLS AND EQUIPMENT

For authorized common tools and equipment, see appendix B, section III, Maintenance Allocation

Chart (MAC).

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

No special tools are authorized for use by general support maintenance. The TMDE and support

equipment are listed in appendix B (MAC), section Ill.

REPAIR PARTS

Repair parts required for general support maintenance are listed and illustrated in appendix D.

Section II GENERAL SUPPORT TROUBLESHOOTING

GENERAL

The following troubleshooting procedures are provided to aid technicians in isolating faults in a

defective cable.

1. Perform all PMCS items in chart on pages 2-5 and 2-6.

2. All cables passing the PMCS procedures will then undergo the insulation breakdown/

leakage test, and the resistance check located in section IV of this chapter.

3-1