APPENDIX D ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT REPAIR

TM 11-5995-208-24&P-1

APPENDIX D

ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT REPAIR

PARTS AND SPECIAL TOOLS LIST

SECTION 1 INTRODUCTION

D-1 . Scope

b. Source, Maintenance, and Recoverability

(SMR) Codes.

This manual lists spares and repair parts;

special tools; special test, measurement, and

(1) Source code. Source codes indicate the

diagnostic equipment (TMDE), and other special

manner of acquiring support items for

support equipment required for performance of

maintenance, repair, or overhaul of end items.

organizational, direct support and general support

Source codes are entered in the first and second

maintenance of the CX-11230A/G (1320 FOOT) and

positions of the Uniform SMR Code format as

the CX-11230A/G (100 FOOT). It authorizes requisi-

follows:

tioning and issue of spares and repair parts as in-

dicated by the source and maintenance codes.

Definition

Code

D-2. General

PA -- Item procured and stocked for antici-

pated or known usage.

This Repair Parts and Special Tools List is divided

into the following sections:

XA -- Item is not procured or stocked

because the requirements for the

a. Section II. Repair Parts List. A list of spares

i t e m will result in the replace-

and repair parts authorized for use in the perfor-

ment of the next higher assembly.

mance of maintenance. The list also includes

parts which must be removed for replacement of

the authorized parts. Parts lists are composed of

NOTE

functional groups in numeric sequence, with the

parts in each group listed in figure and item

Cannibalization or salvage may be

number sequence.

used as a source of supply for any items

b. Section

III.

Special

Tools

List.

Not

source coded above except those

coded XA and aircraft support items

applicable.

as restricted by AR 750-1.

c. Section IV. National Stock Number and Part

Number Index. A list, in National item identifica-

(2) Maintenance code. Maintenance codes

are assigned to indicate the levels of maintenance

tion number (NIIN) sequence, of all National stock

authorized to USE and REPAIR support items. The

numbers (NSN) appearing in the listings, followed

maintenance codes are entered in the third and

by a list, in alphameric sequence, of all part

fourth positions of the Uniform SMR Code format

numbers appearing in the listings. National stock

as follows:

numbers and part numbers are cross-referenced

t o each illustration figure and item number

(a) The maintenance code entered in the

appearance.

third position will indicate the lowest

maintenance level authorized to remove, replace,

D-3. Explanation of Columns

and use the support item. The maintenance code

entered in the third position will indicate one of

a. Illustration.

This

column

divided

the following levels of maintenance:

follows:

Application/Explanation

(1) Figure n u m b e r . Indicates the figure

Code

number of the illustration on which the item is

Support item is removed, replaced,

shown.

used at the organizational level.

H - Support item is removed, replaced,

(2) Item number The number used to iden-

used at the general support level.

tify item called out in the illustration.

D-1