|
|
MISCELLANEOUS MAINTENANCE
VEE BELTS
CHECKING BELTS
ADJUSTING BELT TENSION
1. Check belt wear.
Alternator Drive (Fig. A)
2. Check tension of each belt.
1. Loosen the bolts on the alternator.
If one belt in a set requires replacement, always intall a
2. Move the alternator until the belt is properly ad-
new matched set of belts-never replace just the worn belt.
Justed. Tighten the adjustment bolt.
If only the worn belt is replaced, the new belt will be
3. Check the adjustment.
carrying all of the load-as it will not be stretched r much
4. Tighten the bolt.
as the older belts-and all of the belts will fall in rapid
succession.
In the following illustrations the pulley marked X is
the adjusting pulley. The pulley marked C Is the crank-
shaft. Force Is applied at the arrow. See the chart for the
force and belt deflection.
FIG. HIGH MOUNT FAN DRIVE
FIG. A ALTERNATOR DRIVE AND WATER PUMP
DRIVE
BELT
FOR SCHEMATIC
ATTACHMENT
FORCE
DEFLECTION
SEE:
Alternator Drive
5 Ibs.
227 gms.
0.25 In.
6.5 mm
FIG. A
Water Pump-Fan Drive
5 lbs.
227 gms.
0.25 in.
6,5 mm
FIG. A
High Mount Fan Drive
5 Ibs.
227 gms.
0.26 In.
6,5 mm
FIG. B
Air Compressor Drive
6 Ibs.
272 gms.
0.25 in.
6,6 mm
FIG. C
Air Compressor Drive
w/high mount fan
4 Ibs.
182 gms.
0.12 in.
3,0 mm
FIG. D
22
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |