Click here to make tpub.com your Home Page

Page Title: Indicator Light Assembly (A18, A19), Replacement
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 32-5865-069-24&P
(3) Disconnect the coaxial connector at the E1 end of the cable.
(4) Remove the cable from the unit.
(5) To install a replacement cable, reverse the procedure detailed in
steps d.(1) thru d.(4). Torque the SMA connector to 8 inch-pounds.
(6) Replace top and bottom covers, refer to para 5-4.1.
e. Remove cable assemblies W18 thru W20 as follows:
(1) Remove A14, refer to para 5-4.2 for procedure. Store A14 safely.
(2) Disconnect the connector at the J1 end of the cable. Refer to
CAUTION
When unfastening cable-ties, take care not to cut or damage the
wiring in the wiring harness.
(3) Unfasten the cable ties securing the cable to the wire harness.
(4) Using extraction tool CET-C6B, remove the coaxial contact from XA14P2
at the El end of the cable. Refer to table 5-5.
(5) Remove the cable from the unit.
(6) To install a replacement cable, reverse the procedure detai led in
steps e.(1) thru e.(5).  Torque SMA connectors to 8 inch-pounds.
(7) Replace top and bottom covers. Refer to para 5-4.1.
5-4.12 Indicator Light Assembly (A18, A19), Replacement.  A18 and A19 are mounted
on the front panel.  Replace a faulty assembly as described in the following
subparagraphs.
NOTE
Individual indicator lights can be replaced without removing the
assembly from the unit. Refer to para 5-9.
To remove a defective assembly from the unit carry out the
5-4.12.1 Removal.
following steps:
a. Lower the front panel as follows:
CAUTION
An RFI gasket is fitted to the panel.  Ensure the gasket is undamaged
-
and seats properly when the panel is replaced.
(1) Unscrew the rubber boot on the POWER RESET actuator. The boot should
be finger-tight.
5-29

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business