MAINTENANCE OF POWER MONITOR CCA (A17)

TM 32-5865-069-24&P

(9) Solder the wires to FL1, FL2 and E1. Refer to table 5-7, a wire chart

for the assembly.

b. To replace filter FL1, FL2:

(1)

Remove and retain the six screws, flat washers and lock washers

securing the cover.

(2)

Unsolder the wire connecting the filter to J21.

Remove and retain the nuts and washers securing the filter to the

(3)

housing.

(4)

Position the replacement filter in the housing and secure with the

hardware retained in step b.(3).

Solder on the wire removed in step b.(2) above.

(5)

Test the assembly using the procedure detailed in table 5-6.

(6)

(7)

Secure the cover using screws and washers retained in step b.(1)

above.

Filter Assembly EMI (A16), Wire Chart

Wire No.

From

FL1-2

J1-A

J1-B

FL2-2

J1-C

5-8. MAINTENANCE OF POWER MONITOR CCA (A17). A17 may be repaired by replacing

faulty components. Refer to table 5-8 for test procedure and troubleshooting

information. Refer to NAVTORPSTA REPORT 1347, Guide Manual for Repair of Elec-

tronic Modules, for component replacement procedures.

5-9. REPAIR OF INDICATOR LIGHT ASSEMBLY (A18, A19). A18 and A19 may be repaired

by replacing faulty or damaged components. Inspect the assembly as described in

table 5-9. Replace faulty components as follows:

a. Replace faulty indicator lens(es) as follows:

NOTE

Lens(es) may be replaced without removing the assemblies from the

unit.

(1) Using a smal 1 flat point screwdriver in the groove at the top of the

indicator light assembly, gently lift out the lens.

(2) Pull the lens out to the extent of the retaining spring.