REPLACEMENT OF PARTS - TM-11-6665-209-200016

TM 11-6665-209-20

2-6.

REPLACEMENT OF PARTS

a. This section gives the necessary procedures to repair and replace damaged parts

on Radiac Sets AN/PDR-27(#).

b. The

column gives the area of the damaged item.

c. The

column tells what item must be replaced.

d. The

column describes the steps to be followed in order to replace and repair

the damaged item.

TABLE 2-4. REPLACEMENT OF PARTS

Action

Task

Item No.

Location

1) Completely loosen the 3 captive

Replace rubber

Battery

screws

gasket

Compart-

2) Remove the battery compartment

(diagram 1)

ment

cover.

3) Inspect the rubber gasket for dam-

age, (tears, frays, excessive wear and

looseness). If the rubber gasket is dam-

aged, then remove the gasket.

4) Secure a new rubber gasket in place with

cement. Make sure that the gasket is

seated properly in the recessed groove

and remove any excess cement from

around the edges.

5) Let the cement dry for 5-10 minutes, then

replace the battery compartment cover.

6) Tighten the 3 captive screws.

Tighten the screws securely in

order to maintain a watertight

battery compartment. Do not

tighten too tightly or damage

may result to the rubber

gaskets.

2-5