 |
|||
|
|
|||
|
Page Title:
MAINTENANCE SUPPORT EQUIPMENT-CONT. |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-l
TM 11-5805-663-14-13
NAVELEX 0967-464-0010
Table 6-l.
Maintenance Support Equipment (cont)
EQUIPMENT IDENTIFICATION
CHARACTERISTICS
Card extender equipped with one cable and two plugs
PC Card Extender STELMA
Part No. 80331740-000
(one on each end of the cable); provides electrical
connections between PC card being extended and
Processor.
PERFOR
NCE TEST TABLES (EXCLUDING
AUTOLOAD, PARALLEL I/O,
a . Remove translucent RF1 bezel on
CONTROLLER, AND I/O CO
front of Processor (AlA3) and open front
Before start of performance sts detailed
panel (Program Maintenance Panel).
in tables 6-2 through 6-8, check that all
power switches in Data Processing Assem-
b. On Processor Auto Load PC card
A1 and TTY (KSR-35 at ACOC Group,
AlA3A9, set the four red toggle switches,
-35 at Switch Group) are ON. All tests
designated from top to bottom as S1 through
are contained on one ATP test tape as de-
S4, as follows: S1 and S2 to up position,
scribed in paragraph 6-12. Listed below
S3 and S4 to down position.
are the Processor and Core emory tests
and the applicable performance test table
ount and thread test tape on Mag
reference. To execute any particular per-
t 1 (A1A1) and a blank tape on Mag
formance test table, autoload the ATP test
Tape Unit 2 (AlA6).
tape as described in paragraph 6-15, then
follow the specific instructions given in
d. On both Mag Tape Units, perform the
that performance test table. Once the
following:
test(s) is completed perform the procedures
of paragraph 6-16 to restore the Cm-e Mem-
1. Press LOAD switch.
ory program.
2.
era tape movement stops press
Test Table
Performance Test
LOAD swit
Reference
again.
6-2
en LOAD lamp is lighted,
6-3
6-4
6-5
6-6
6-7
6-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals