|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
AUTOMATIC TIMING ADVANCE
INSTALL AUTOMATIC TIMING ADVANCE
12-1272
1.
If the timing mark on the crankshaft and the
timing mark on the camshaft gear are not in
alignment, turn the crankshaft clockwise (as
seen from the front of the engine) until the
marks are in alignment.
2.
Put the dowels in the gear in alignment with the
holes in the weights and install the automatic
timing advance.
3.
Put pin (2) in washer in alignment with hole (3)
in the camshaft and install washer (1).
4.
Install screw (4) and tighten it to a torque of
108 36 lb. in. (124.5 41.5 cm. kg). Put
marks (stake) on the screw in two places with a
hammer and punch.
CAUTION: Put marks (stake) on screw (4) carefully.
Too much force pushes the shaft extension into the
camshaft and takes away all end clearance.
5.
After putting marks (stake) on the screw (4),
the end clearance for the gear and weight
assembly must be .003 to .037 in. (0.08 to 0.94
mm). This end clearance will prevent binding
against the washer, camshaft end, or camshaft
gear.
end by:
a)
install timing gear cover and oil pump
87
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |