Click here to make tpub.com your Home Page

Page Title: REMOVE TIMING GEAR COVER AND OIL PUMP (INDUSTRIAL ENGINE) 11-1166 & 1304
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
TIMING GEAR COVER AND OIL PUMP
REMOVE TIMING GEAR COVER AND OIL
PUMP (INDUSTRIAL ENGINE) 11-1166 & 1304
Tools Needed
A
8S6692
Water Sleeve Tool
1
start by:
a)  remove oil pan
b)  remove crankshaft pulley
1.
Remove oil pump suction pipe.
2.
Remove two nuts (2) and tachometer drive
housing (I).
3.
Remove the four bolts (7) that hold the front
support (8) to the timing gear cover.
4.
Disconnect water outlet elbow (5) from the oil
cooler.
5.
Disconnect fuel lines from the fuel filter base.
6.
Remove the clamps from the water sleeves in
each cylinder head. Push the sleeves into the
timing gear cover with tool (A).
7.
Remove connector (3).
8.
Remove the bolts (4) that hold the timing gear
cover to the cylinder block. Be sure to remove
the bolt that is behind elbow (6).
Put
identification of the bolts as to their location for
use at assembly.
CAUTION: Be extra careful not to cause damage to the
crankshaft front seal during removal and installation of
the timing gear cover.
9.
Install two 7/16"-14 NC forged eyebolts in the
timing gear cover. Fasten a hoist and remove
timing gear cover (9) and the oil pump from the
dowels on the cylinder block. The weight of the
timing gear cover and oil pump is 136 lb. (62
kg).
80

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business