|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
TIMING GEAR COVER AND OIL PUMP
INSTALL TIMING GEAR COVER AND OIL
PUMP (MARINE ENGINE)
12-1166 & 1304
Tools Needed
A
8S6692
Water Sleeve Tool
1
1.
Clean the contact surfaces of the cylinder block
and timing gear cover. Install the timing gear
cover gasket on the cylinder block.
NOTE: Make sure the water sleeves are installed in the
timing gear cover. Put oil on the seals.
2.
Install two 7/16"- 14 NC forged eyebolts in the
timing gear cover. Fasten a hoist and put the
timing gear cover (1) and the oil pump in
position on the engine. Make sure the oil pump
gear and crankshaft gear are in alignment.
3.
Install the bolts that hold the cover in place.
4.
Push the water sleeves into the cylinder heads
with tool (A). Install clamps.
5.
Put the engine front support (8) in position and
install the bolts (7) that hold it in place.
6.
Install elbow (6) and bolts that hold it to the
timing gear cover. Connect water lines (2) and
7.
Install tachometer drive adapter (3) and the
bolts that hold it.
8.
Install elbow (5) and sea water pump (9).
end by:
a) install oil pan
b) install crankshaft pulley
c) install sea water pump
d) install expansion tank and heat exchanger
79
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |