|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
TIMING GEAR COVER AND OIL PUMP
INSTALL TIMING GEAR COVER AND OIL
PUMP (INDUSTRIAL
ENGINE)
11-1166 & 1304
Tools Needed
A
8S6692
Water Sleeve Tool
1
1.
Clean the contact surfaces of the cylinder block
and timing gear cover. Install the timing gear
cover gasket on the cylinder block.
NOTE: Make sure the water sleeves are installed in the
timing gear cover. Put oil on the seals.
2.
Install two 7/16"- 14 NC forged eyebolts in the
timing gear cover. Fasten a hoist and put
timing gear cover and the oil pump in position
on the engine. Make sure the oil pump gear
and crankshaft gear are in alignment.
3.
Install the bolts that hold the cover in place.
4.
Install the connector.
5.
Push the water sleeves into the cylinder heads
with tool (A). Install clamps.
6.
Put the engine front support in position and
install the bolts that hold it in place. Install the
tachometer drive housing.
7.
Connect the fuel lines to the fuel filter base.
8.
Connect water outlet elbow to the timing gear
cover,
9.
Install oil pump suction pipe.
end by:
a) install crankshaft pulley
b) install oil pan
81
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |