|
|
BASIC BLOCK
TESTING AND ADJUSTING
2. Set the dial indicator to read .000 in. (0.0 mm).
3. Turn the flywheel and read the indicator every 90 .
4. The difference between the lower and
higher
measurements taken at all four points must
not be
more than .006 in. (0.15 mm), which
is the
maximum
permissible
bore
runout
(radial
eccentricity) of the flywheel.
5. Runout (eccentricity) of the bore for the pilot bearing
for the flywheel clutch, must not exceed .005 in.
(0.13
mm.).
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |