CHAPTER 2 ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 32-5865-069-24&P

CHAPTER 2

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

2-1. SCOPE. This chapter provides the information for the performance of organ-

izational maintenance personnel by the Maintenance Allocation Chart (MAC).

TOOLS AND EQUIPMENT

Section I.

2-2. TOOLS AND EQUIPMENT. Refer to the MAC in Appendix B and the Repair Parts

and Special TOOlS List (RPSTL) in Appendix C.

REPAINTING AND REFINISHING INSTRUCTIONS

Section II.

2-3. REPAINTING AND REFINISHING INSTRUCTIONS . For touch up painting instruc-

tions, refer to the applicable cleaning and refinishing practices specified in TB

43-0118, Field Instructions for Painting and Preserving Electronics Command Equip-

ment, including Camouflage Pattern Painting of Electrical Equipment Shelters.

Surfaces which are exposed when the RSPU is mounted in the system will be painted

color No. 24410. Refer to Appendix D for details of the materials to be used.

LUBRICATION INSTRUCTIONS

Section III.

NOTE

Lubrication is not required.

PREVENTIVE MAINTENANCE CHECKS AND SERVICES

Section IV.

2-4. GENERAL . Preventive Maintenance Checks and Services (PMCS) are essential

for the efficient operation of the RSPU. PMCS will aid in discovering and

correcting defects before they result in serious malfunctions. The checks and

services are listed in table 2-1. PMCS shall be accomplished in accordance with

the following:

if the equipment fails to operate, refer to para 2-5.

b. Report any defects using proper forms. Refer to TM 38-750, (TAMMS).

TROUBLESHOOTING

Section V.

2-5. TROUBLESHOOTING. Troubleshooting consists of performing the system BITE

test. When the symptom is identified as a faulty RSPU inform Direct Support ( DS).

Refer to TM 32-5865-060-10 for the BITE procedure. Troubleshooting allocated to

General Support (GS) shall be in accordance with the MAC.

2-1