APPENDIX C ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST

TM 32-5865-069-24&P

APPENDIX C

ORGANIZATIONAL, DIRECT SUPPORT, AND

GENERAL SUPPORT MAINTENANCE

REPAIR PARTS AND SPECIAL TOOLS LIST

INTRODUCTION

Section I.

C-1. SCOPE. This manual lists spares and repair parts, special tools; special

test, measurement, and diagnostic equipment (TMDE), and other special support

equipment required for performance of organizational, direct support, and general

support maintenance of the Processor, Signal Data MX-10214/MLQ-34. It authorizes

the requisitioning and issue of spares and repair parts as indicated by the source

and maintenance codes.

C-2. GENERAL. This Repair Parts and Special Tools List is divided into the

following sections:

a. Section II. Repair Parts List. A list of spares and repair parts author-

ized for use in the performance of maintenance. The list also includes parts

which must be removed for replacement of the authorized parts. Parts lists are

composed-of functional groups in numeric sequence, with the parts in each group

listed in figure and item number sequence. Bulk materials are listed in NSN

sequence.

b. Section III. Special Tools List. A list of special tools, special TMDE,

and other special support equipment authorized for the performance of maintenance.

Section IV. National Stock Number and Part Number Index. A list, in

National item identification number (NIIN) sequence, of all National stock numbers

(NSN) appearing in the listings, followed by a list in alphameric sequence of all

part numbers appearing in the listings. National stock numbers and part numbers

are cross-referenced to each illustration figure and item number appearance. This

index is followed by a cross-reference list of reference designators to figure and

item numbers.

C-3. EXPLANATION OF COLUMNS.

Illustration. This column is divided as follows:

Indicates the figure number of the illustration on

(1) Figure Number.

which the item is shown.

The number used to identify item called out in the

(2) Item Number.

illustration.

C-1