Inspection - TM-3-1375-201-100014

TM 3-1375-201-10

i. Discard the packing material (See Note ahead of

operating instructions (fig. 2-4) in a suitable area.

Retain the preparation instructions (fig. 2-1) for possible

j. Establish an emergency plan for movement of

reuse.

classified material to the destruction site. Post the

Figure 2-4. Illustration of operating instructions.

(The oxidizer can be either loose, beads, or caked.) If all

2-2.

Inspection

parts are intact, install a new wire lead seal (para 2-1h).

a. While preparing the document destroyer (para 2-

If water is present in document destroyer, the document

1), it should be inspected to see that it is undamaged.

destroyer-should be discarded and replaced.

b. Periodically check that wire lead' seal (fig. 2-3)

is intact and that the contents have not been tampered

2-3.

Repacking

with. If missing or broken, do not operate the document

a. Use the following procedure if the original

destroyer without first checking to see that the screen

cover, inner drum, three igniters, two railroad fusees, and

packing materials were saved:

oxidizing agent are present and in good condition.

(1) Remove the igniters and fusees from the

document destroyer.

2-5