Figure 2-1. Illustration of preparation instructions.

TM 3-1375-201-10

d. Remove the inner drum cover. Be sure to

that the igniters inside are not damaged. Flatten the

igniters before attempting to insert them in the area

remove the extra lead seal which is taped to the inner

between the drums. Place the three igniters on top of

drum cover and save the lead seal for later use. Discard

the exposed oxidizing agent. Press the igniters into

the inner drum cover.

place by starting at one end and working around the

e. Remove the box containing the fusees from the

space between the drums. The three igniters should go

completely around the circumference. Lift one end of

inner drum. Remove the fusees from the box and retain

each bag upward beyond the top of the inner drum as

them. Squeeze the screen cover and pull upward to

shown in figure 2-2. Hang the fusees on the edge of the

remove the screen cover. Then remove the fiberboard

inner drum.

lower cell. Open the top of the fiberboard box which is

attached to the fiberboard lower cell. Pull out the vapor

barrier bag. Slit open the vapor barrier bag carefully so

2-2