FOG OIL TANK ASSEMBLY.

TM 3-1040-279-12&P

4-42 FOG OIL TANK ASSEMBLY.

This task covers replacement of:

a. Fog Oil Tank and Insulating Pads (P. 4-172)

b. Retaining Straps and Anchor Straps (P. 4-174)

INITIAL SETUP

Materials

Tools

Dry Cleaning Solvent (item 4, App E)

General Mechanic's Automotive Tool Kit

Rags (item 11, App E)

SC 5180-90-CL-N26

Adhesive (Item 1, App E)

a. Fog Oil Tank and Insulating Pads.

NOTE

The following procedure applies to one insulating pad. All pads are

removed/installed the same way.

REMOVAL

Remove fog oil pump assembly (P. 4-21).

Use appropriate container and drain fog oil tank (1) thru ball valve (2).

Loosen and remove nut (3), washer (4) and spring (5) on both retainer straps (6).

Loosen but do not remove two screws (7) securing forward restraint (8), and move restraint away

from fog oil tank (1).

Remove fog oil tank (1) from baseplate (9)

INSPECTION/REPAIR

Inspect baseplate pad (10), forward restraint pad (11), side restraint pads (12), top restraint pad (13)

and rear restraint pad (14).

Replace pads if tom or otherwise damaged (Fig. 11 thru 14, App G).

Lift edge of pad (11) with sharp tool.

Remove pad completely from restraint (8).

Clean restraint mounting surface with dry cleaning solvent (Item 4, App E) and rags (Item 11, App

E).

Apply thin coat of adhesive (Item 1, App E) to pad (11) and restraint (8). Allow to dry for 10 to 20

minutes, then press surfaces together.

INSTALLATION

NOTE

For installation it may be necessary to remove one of the side restraints (P.

Position fog oil tank (1) in baseplate (9).

Change 4

4-172