TERMINAL BRACKET ASSEMBLY.

TM 3-1040-279-12&P

4-23 TERMINAL BRACKET ASSEMBLY.

This task covers replacement of:

a. Terminal Board TB12 (P. 4-96)

b. FUEL, AIR, ENG, or OIL Switch (P. 4-97)

INITIAL SETUP

General Safety Instructions

Before performing any maintenance proce-

Tools

dures be sure circuit breaker CB1 is in OFF

General Mechanic's Automotive Tool Kit

position.

SC 5180-90-CL-N26

Before performing any maintenance procedures

on air lines be sure to relieve system of pres-

sure through control valve on pressure tank.

Materials

Fog oil is very slippery, wipe up all spills

Sealing compound (Item 11A, App E)

immediately to prevent injury to personnel.

a. Terminal Board TB12

REMOVAL

1. Remove terminal bracket assembly from equipment container (P. 4-74).

2. Remove four screws (l), washers (2), and nuts (3), and remove terminal board (4).

INSTALLATION

1. Position terminal board (4) and secure using four screws (1), washers (2), and nuts (3).

2. Install terminal bracket assembly in equipment container (P. 4-74).