CHAPTER 4 ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 3-1040-279-12&P

CHAPTER 4

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND

DIAGNOSTIC EQUIPMENT TMDE; AND SUPPORT EQUIPMENT

4-1 COMMON TOOLS AND EQUIPMENT.

For authorized common tools and equipment refer to the Modified Table of Organization and Equipment

(MTOE) applicable to your unit.

4-2 SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.

No special tools or equipment are required for organizational maintenance.

4-3 REPAIR PARTS.

Repair parts are listed in Appendix F of this manual.

Section II. SERVICE UPON RECEIPT

4-4 CHECKING UNPACKED EQUIPMENT.

a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,

report the damage on SF Form 364, Report of Discrepancy.

b. Check the equipment against the packing slip to see if the shipment is complete. Report all

discrepancies in accordance with the instructions in DA PAM 738-750.

c. Check if the equipment has been modified.

4-5 INSTALLATION.

Refer to TM 9-2350-261-20-1 for M1059 vehicle installation procedures or TM 3-1040-280-20&P for

M1037/M1097 vehicle installation using M284 mounting kit.

4-6 OPERATING CHECK.

a. Perform operator PMCS (P. 2-5).

b. Adjust fuel pump pressure (P. 4-62).

c. Adjust fog oil pressure relief valves (P. 4-145).

d. Start and operate smoke generator (P. 2-10.6).

4-1

Change 4