Section IV. PAINTING - TM-3-1040-214-340016

(5) Perform test in c below.

(2) Check to see that the coupling cap (A, fig 2-1)

is installed.

(6) Connect the carrier pack (8, fig 2-8)

the

(3) Open the pressure tank valve by turning the

frame with the cords (9) removed in a(2) above.

(7) Connect the straps (removed in a(5) above) to

valve handle (B, fig 2-1) counterclockwise.

(4) Apply soapy water around all the connections

the frame.

and fittings and check for leaks.

(5) Retighten all fittings if leaks are found and

Test.

perform (4) above.

(1) Close the shutoff valve (2, fig 2-6) by turning

the handle clockwise.

Section IV. PAINTING

2-7. General

2-8. Paints to be Used

Primer. Prime all worn and scratched

Direct support maintenance personnel are authorized to

repaint the disperser.

surfaces with one coat of appropriate primer.

b. Enamel. Repaint all previously painted

surfaces with green lusterless enamel.

2-10