SECTION I INTRODUCTION - TM-11-6625-273-34P0002

SECTION I

INTRODUCTION

Code

Explanation

1-1. Scope

PE-Support equipment procured and stocked

This manual lists repair parts and special tools

for initial issue or outfitting to specified

required for the performance of direct support,

maintenance repair activities.

general support, and- depot maintenance of the

PF-Support equipment which will not be

AN/GSM-6 and AN/GSM-6A. The PCCN for the

stocked but which will be centrally pro-

equipment is GTEAAU for all models.

cured on demand.

1-2. General

PG-Item procured and stocked to provide for

sustained support for the life of the equip-

This repair parts and special tools list is divided

ment. It is applied to an item peculiar to

into the following sections:

the equipment which because of probable

a. Repair Parts List--Section II. A list of re-

discontinuance or shutdown of production

pair parts authorized for the performance of

facilities would prove uneconomical to re-

maintenance at' the direct support, general sup-

produce at a later time.

port, and depot level. This repair parts list is ar-

KD-An item of depot overhaul/repair kit and

ranged in alphabetical order.

not purchased separately. Depot kit defined

b. Special Tools, Test and Support Equipment

as a kit that provides items required at the

-Section III. Not applicable.

time of overhaul or repair.

c. Index-Federal Stock Number and Reference

KF-An item of a maintenance kit and not pur-

Number Cross-Reference to Figure and Item

chased separately. Maintenance kit defined

Number-Section IV. A list, in assending numeri-

as a kit that provides an item that can be

cal sequence, of all Federal stock numbers ap-

replaced at organizational or direct support

pearing in the listings, followed by a list, in

or general support levels of maintenance.

alphameric sequence, of all reference numbers

KB-Item included in both a depot overhaul/re-

appearing in the listings. Federal stock number

pair kit and a maintenance kit.

and reference numbers are cross-referenced to

MO-Item to be manufactured or fabricated at

each illustration figure and item number or

organizational level.

reference designation appearance.

MF-Item to be manufactured or fabricated at

1-3. Explanation of Columns

direct support maintenance level.

MH-Item to be manufactured or fabricated at

The following provides an explanation of columns

general support maintenance level.

found in the tabular list.

a. Source, Maintenance, and Recoverability

MD-Item to be manufactured or fabricated at

depot maintenance level.

Codes (SMR).

AO-Item to be assembled at organizational level,

(1) Source code. Indicates the manner of ac-

quiring support items for maintenance, repair, or

AF-Item to be assembled at direct support

overhaul of end items. Source codes are

maintenance level.

Explanation

Code

AH-Item to be assembled at general support

PA-Item procured and stocked for anticipated

maintenance level.

or known usage.

AD-Item to be assembled at depot maintenance

PB-Item procured and stocked for insurance

level.

purposes because essentiality dictates that

XA-Item is not procured or stocked because the

a minimum quantity be available in the

requirements for the item will result in the

supply systems.

replacement of the next higher assembly.

PC-Item procured and stocked and which

XB-Item is not procured or stocked. If not avail-

otherwise would be coded PA except that

able through salvage, requisition.

it is deteriorative in nature.

XC-Installation drawing, diagram instruction

PD-Support item, excluding support equip-

sheet, field service drawing, that is identi-

ment, procured for initial issue or out-

fied by manufacturers' part number.

fitting and stocked only for subsequent or

additional initial issues or outfittings. Not

XD-Support items can be requisitioned with

subject to automatic replenishment

justification.