SECTION V. TROUBLESHOOTING - TM-11-5920-252-240038

TM 11-5920-252-24

SECTION V. TROUBLESHOOTING

Section Contents

Paragraph

General ..........................................................................................

3-16

Test Equipment ..............................................................................

3-13

Troubleshooting..............................................................................

3-18

Test Set TS.3760/G In Diode Mode ..............................................

3-19

Test Set TS-3760/G In Spark Gap Mode .......................................

3-20

Removal and Replacement ............................................................

3-21

3-16.

GENERAL

When it has been determined that the arrester has a faulty circuit, the arrester is removed and replaced with another

arrester. Repair of the arrester requires a higher level of maintenance.

Troubleshooting the arrester is necessary when:

A communications channel within the shelter is inoperable because of the absence of the

channel's Input signal, communications systems control, or communications system's output

signal from the shelter.

An arrester circuit does not check ok during the test' performed in Section IV, Table 3-1.

3-17.

TEST EQUIPMENT

The following test equipment(s) are required for troubleshooting the arrester.

Test Set TS-3760/G

3-15