 |
|||
|
|
|||
|
Page Title:
Table 6-10. Processor Interrupt Test Number Definitions |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-1
TM 11-5805-663-14-13
NAVELEX 0967-464-0010
CM MSA PC card contains a 2.75 volt dc
error messages. It should be noted that
during performance tests that utilize GINS I
power supply which supplies core matrix
drive current. The 2.75 volt power supply
through IV, memory address, random data,
adjustment is described below.
and worst pattern memory acceptance tests
no TTY error print outs are generated.
a . With system power turned off, re-
move BSM and place on extenders.
PRINTOUTS. If an error is detected during
b. Turn on system power.
the Processor interrupt test, the TTY will
type a standard error message in the follow-
c. Connect dc voltmeter between Q2-C
and pin Pl-1 on CM MSA and check that a
ing format:
measurement of 2.75 volts dc is obtained.
If necessary adjust Rl for proper reading.
T xx A yyyy B z
TEST ERROR PRINTOUTS.
Where xx indicates the test number in which
the error was detected, yyyy indicates the
6-26. When the interrupt, LF and power
program address where the error occurred,
fail restart, control panel, teletype 33/35,
and z indicates the type of error. See
or SUE Mag tape (BTA) acceptance tests are
used during a performance test, standard
and table 6-11 for definitions of types of
error messages may be printed on the TTY.
errors.
The following paragraphs describe these
DEFINITION
TEST NUMBER
Detect Level 1 Interrupt Test
01
Enable and Wait Level 1 Interrupt Test
02
Disable and Wait Level 1 Interrupt Test
03
Wait for Interrupt Level 1 Test
04
Detect Level 2 Interrupt Test
06
Enable and Wait Level 2 Interrupt Test
07
Disable and Wait Level 2 Interrupt Test
08
Wait for Interrupt Level 2 Test
09
Detect Level 3 Interrupt Test
10
Enable and Wait Level Three Interrupt Test
11
Disable and Wait Level 3 Interrupt Test
12
Wait for Interrupt Level 3 Test
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals