 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-405-10
(8) Remove the film guide and insert the film
the PH-256-A during development to
keeper into its slots in the tank body.
provide agitation.
(9) Place the light trap, with the projections
(14) When the continuous timer indicates that
pointing upward, over the panel. The
the required developing time has elapsed,
circular cut-out in the light trap must be
drain the developer solution from the PH-
adjacent to the pouring spout.
256-A.
(10) Place the cover over the light baffle lip and
(15) Rinse, fix, and wash the negatives (par.
then press the cover into place.
(11) Turn on the darkroom lights.
b. Photographic Processing Tank FM-8 (1) (fig.
(12) Check the temperature of the developer
solution
(TM
11-401)
with
the
proceed as follows:
thermometer, start the continuous timer
(1) Adjust the FM-8(1) for the 4by 5inch cut
film (or smaller) by sliding the short hub
solution into the tank body through the
reel onto the main reel shaft until it clicks
hole in the center of the cover.
into the desired position.
(13) Gently rock the PH-256-A (parallel to the
(2) Attach the film feeder to the main reel as
film) to dislodge any air bubbles that may
follows:
be clinging to the films. Occasionally, rock
Figure 29. Talk PH-256-A.
AGO 5894A
37
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals