ADJUSTMENTS - Continued - TM-11-3895-209-140048

TM 11-3895-209-14

4-16. ADJUSTMENTS - Continued

D Bend up the tab on the key washer to lock the bolt in position.

E Loosen the locknut on the anchor bolt and adjust the anchor bolt to obtain minimum clearance

(approximately 1/64 inch) between the drum and the end of the band anchored by the bolt.

F Tighten the adjusting nut on the adjustment bolt to obtain minimum clearance (approximately

1/64 inch) between the drum and the end of the band to which the cams are attached.

NOTE

When completing adjustment of the nut on the adjusting bolt, be sure that the nut is

turned so that the notch in the bolt fits over the ridge on the end of the band.

4-16