 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-3895-209-14
4-2. UNPACKING- Continued
A Cut and fold back the steel straps. Be
careful of the sharp edges on the steel
straps.
sides of the box with a nail puller.
Remove the top and sides.
C Carefully cut the moisture-vaporproof
barrier down the four corners and pull
the flaps clear of the equipment.
D Carefully cut the tape on the cor-
rugated wrapper and pull the flaps of
the wrapper clear of the equipment.
E Remove the canvas cover.
F Remove the four nuts, washers, and
bolts that secure the RL-207(*)/G to the
skid base.
G Lift the RL-207(*)/G from the skid base.
Use a forklift truck or hoist.
ASSEMBLY OF UNPACKED EQUIPMENT
The RL-207(*)/G is shipped with the upper
control lever removed. The control lever is
wrapped in cushioning material and
secured to the upper reel axle with tape.
Follow the procedure given below to install
the control lever:
A Cut the tape, and remove the control
lever from the upper reel axle. Unwrap
the cushioning material and remove
the control lever.
B Release the fasteners and open the
door on the rear belt guard.
C Turn the upper drive pulley until one of
the oblong holes in the pulley is alined
with the two bolts in the idler arm.
D Remove the two bolts and lock
washers.
E Insert the control lever through the hole
in the top of the belt guard and into the
slot in the idler arm. Aline the boltholes
in the control lever with the holes in the
idler arm.
F Replace the two bolts, and lock
washers and tighten them securely.
4-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals