V-Band Clamps

TB 9-2300-378-14

(h) After each hole is drilled, install bolt, washer and nut to insure air cleaner

dues not shift during subsequent drilling operation (view B).

(i) After drilling all four 5/8 inch holes, loosen all mounting bolts and check for

g a p between air cleaner base plate and outriggers. If a gap exists, use

washers (maximum of three per bolt) to shim gap lighten 5/8 inch mounting.

(j) Apply primer, NSN 8030-00-900-2373 and locking compound. NSN 8030-00-

148-9833, to bolt threads and nuts.

(k) Tighten 5/8 inch bolts to 85-95 1b-ft (115-129) and 3/8 inch bolts to 22-30 lb-

ft (30-41 Nm).

(l) Tighten fender extension mounting bolts.

(m) Connect battery ground cables (TM-20).

4-6. V-Band Clamps (Fig. 4-11)

Figure 4-11.

V-band clamps.

4-16