 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2300-247-40
Figure 19. Reinforcement Plate
e.
Remove front wheel, splash shield, and
40.
Inspection.
fender to provide access as required.
a.
Inspect vehicle frame
for
defects
as
WARNING
described in Section I
Use only effective chip guarding
b.
Perform vehicle frame alinement inspection
equipment, protective equipment and
for vehicles as described in Chapter 3.
protective clothing (goggles, shields,
gloves aprons, etc.) when doing any
41.
Sketches. Prepare sketches to design specific
drilling, grinding, or welding. Failure
repair requirements as required and/or as shown in this
to follow this warning could result in
section.
injury to personnel.
42.
General Repair Procedures.
CAUTION
Welding is not an approved or
a.
Thoroughly clean vehicle frame of all, oil,
acceptable alternate method of repair
grease, dirt, and debris.
for any riveted or bolted attachment
(e.g. crossmember, spring hanger
b.
Perform general vehicle frame inspection
etc.) on the CUCV vehicle series
as specified in Section I.
frame assembly.
c.
Perform vehicle frame alignment inspection
f.
Drill a 3/16-inch hole at the extreme edge of
as specified in Chapter 3.
the crack and bevel the edges of the crack
with a chisel or grinding tool as shown in
d.
Jack up vehicle frame evenly and provide
support directly under crack.
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals