 |
|||
|
|
|||
|
Page Title:
Figure 12. Establishing Reference Line (Right Side) |
|
||
| ||||||||||
|
|
 TB 9-2300-247-40
f.
Refer to Figure 11. Carefully mark spot (4)
NOTE
on paper (3) directly below plumb bob (2).
If plumb bob is not placed towards
the front of the vehicle on both the
g.
Refer to Figure 12. Place one edge of
right and the left grease fittings (1),
square (1) along horizontal line (4) used to
inaccurate
frame
squareness
measure horizontal bow on right side of
measurement will result.
vehicle Make sure that the other edge of
square (1) is touching plumb bob mark (5)
d.
Refer to Figure 11. Place string (6) over
on paper.
grease fitting (1) on inner right front spring
h.
Stretch string (2) along edge of square (1)
shackle (5). Make sure that plumb bob (2)
to the left side of the vehicle.
is to front of vehicle.
i.
Allow string (2) to extend 6 inches beyond
e.
Lower plumb bob (2) and locate a point on
left horizontal (3).
paper (3) below spring shackle (5).
j.
Using tape, secure string (2) securely to the
NOTE
shop floor.
For accuracy, do not make mark on
paper until plumb bob has stopped
swinging and is as close to the paper
as possible without actually touching
the paper.
Figure 12. Establishing Reference Line (Right Side)
k.
Refer to Figure 13. Place string (6) over
NOTE
grease fitting (1) on left front spring shackle
If plumb bob is not placed towards
(5) with plumb bob (3) to front of vehicle.
the front of the vehicle on both the
right and the left grease fittings (1),
l.
Lower plumb bob (3) and locate a point on
an inaccurate measurement of frame
paper (4) below spring shackle (5).
squareness will result.
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals