 |
|||
|
|
|||
|
Page Title:
Undercarriage Preliminary Inspection. |
|
||
| ||||||||||
|
|
 TB 9-2300-247-40
(2) Check
for
loose
or
broken
29.
Equipment Conditions: Vehicle empty and
crossmembers.
vehicle undercarriage clean and completely free of mud,
dirt, and debris.
(3) Check for damaged frame rails.
Reference Publications:
b.
Drive vehicle into inspection position from a
12 foot straight line of travel.
TM 9-2320-211-34-22
TM 9-2320-260-34-2-3
31.
Frame leveling (Figure 5).
TM 9-2320-272-34-1
TM 9-2320-272-34-2
a.
Apply handbrake and chock wheels to
prevent vehicle movement.
30.
Undercarriage Preliminary Inspection.
b.
Using tape measure, measure distance
NOTE
from shop floor to bottom of two front frame
If damage is found during the
rails (1) at front of crossmember (2) as
undercarriage preliminary inspection,
shown.
this damage must be corrected
before vehicle frame alinement can
c.
If either frame rail (1) is lower than the
be completed.
other, use jack and raise lower side at axle
(3) to adjust frame rails (1) to within 1-inch
a.
Perform the following checks:
equal height.
(1) Check
for
loose
or
missing
d.
Record measurements on DA Form 2404.
crossmember rivets.
Figure 5. Frame Leveling
e.
Using tape, measure distance from shop
side at rear axle (6) to adjust frame rails to
floor to bottom of two rear frame rails (4) at
within 1/8-inch equal height.
crossmember (5) as shown.
g.
Record measurements on DA Form 2404.
f.
If either frame rail (4) is lower than the
other, use hydraulic jack and raise lower
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals