 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-3655-214-13&P
4-15. PUMP
This task covers:
a. Removal
d. Disassembly
b. Cleaning
e. Replacement/Repair
c.
Inspection
f.
Reassembly
INITIAL SETUP
Equipment
Condition
Condition Description
Applicable Configurations
Para
All
Equipment is OFF.
Test Equipment
None
Special Tools
Special Environmental Conditions
Extractor, Pump pin
None
Tool Number 12681-133-(13627)
Materials/Parts
General Safety Instructions
Cleaning solvent
Observe Warnings and Cau-
tions
Bristle brush
Wire brush
Personnel Required
MOS 52C
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
WARNING
Make certain that pump has been shutdown and electrical power disconnected. Check that supply cylinder shutoff valve
is closed. Check that pressure has been relieved by opening the blow-off valve and inlet bleed valve.
1. Pump
a. Remove pump pulley (see paragraph
4-11).
b. Refer to illustration at the end of this
section and disconnect lines and fit-
tings (1) from pump tee fittings.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals