Section III. DIRECT SUPPORT TROUBLESHOOTING

TM 5-3610-254-14

Section III. DIRECT SUPPORT TROUBLESHOOTING

5-7. INTRODUCTION TO DIRECT SUPPORT TROUBLESHOOTING

a. This section contains troubleshooting information for locating and correcting most of the operating troubles which

may develop in the editorial unit of the special warfare printing plant. Each malfunction for an individual

component, unit, or system is followed by a list of tests or inspections which will help you to determine corrective

actions to take. You should perform the tests/inspections and corrective actions in the order listed.

b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a

malfunction is not listed or is not corrected by listed corrective actions in this manual, then refer to commercial

manual. If at this point you cannot correct the malfunction, notify your supervisor.

c. Refer to table 5-1 for troubleshooting information and procedures applicable to the editorial shelter system and

components.

Table 5-1. DIRECT SUPPORT TROUBLESHOOTING

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

SHELTER SYSTEM AND COMPONENTS

AIR CONDITIONING UNIT DOES NOT HEAT

NOTE

For maintenance and repair procedures pertaining to the air conditioner refer to TM 5-4120-239-14,

Operator, Organizational, Direct Support and General Support Maintenance (TRANE models) or TM

5-4120-340-14, Organizational, Direct Support and General Support Maintenance Manual Air

Conditioner (KECO models).

Step 1.

Inspect air conditioner control box function switch as follows:

Position the AIR CONDITIONER circuit breaker to OFF.

5-2