TACK-BOARD ASSEMBLY

TM 32-5410-215-14&P

(1) Insert new standoff (1) in shelf hole (4).

5-24 TACK-BOARD ASSEMBLY. See figure E-12.

Secure standoff to shelf using a flaring tool and backup

tool.

a. Removal. Procedures detailed in paragraphs 5-

(2) Insert spring (1) into standoff (1).

18 a and b must be accomplished before proceeding

with paragraph b below.

NOTE

b. Disassembly.

(1) Remove four retaining brackets (3, 5, 6, 7)

To ensure a proper fit, the knob and

from tack-board assembly (9) by removing eight screws

pin must remain aligned with each

(2).

other during the press procedure in

(2) Remove tack-boards (4, 8) from frame (9).

step (3) below.

c. Assembly.

(3) Insert pin (1) and knob (1) into standoff (1)

(1) Position tack-boards (4, 8) in frame (9).

and press them together using a bench vise.

(2) Install four retaining brackets (3, 5, 6, 7)

(4) Install shelf (4) into lower cabinet (2).

using eight screws (2).

(5) Install latch plate (7) on door (16) using

two flat washers (6), screws (5), and nuts (18).

d. Installation. Perform procedures detailed in

(6) Insert modified link lock (20) and spring

paragraphs 5-18 c and d.

(23) into bracket (19) and secure using spring pin (24).

(7) Install bracket (19) on door (10) using two

5-25 CHAIR TIEDOWN ASSEMBLY. See figure E-14.

flat washers (6), screws (5), and nuts (3).

(8) Install knob (22) on modified link lock (20)

a. Removal.

using spring pin (21).

(1) Turn chair (1) on its side and prop it to

(9) Install two slide blocks (14) on each door

allow access to and removal of tiedown assembly spring

bottom (10, 16) using eight flat washers (8), screws (15),

pin (9).

and nuts (9).

(2) Remove spring pin (9) using a standard

(10) Position doors (10, 16) in door frame (11).

3/16inch punch and hammer.

(11) Align top slide block mounting holes in

(3) Pull tiedown assembly (2) away from chair

door (10, 16) with door frame access holes (11).

stem (1).

(12) Install two slide blocks (14) on each door

top (10, 16) using eight flat washers (8), screws (15), and

b. Installation.

nuts (9).

(1) Slide tiedown housing (8) into chair stem

(13) Install sliding door assembly (11) on lower

(1). Align spring pin holes.

cabinet assembly (2) using 10 flat washers (12), screws

(2) Set spring pin (9) and tap in place with

(13), and nuts (3).

hammer.

(3) Turn chair upright.

d. Installation. Perform procedures detailed in

paragraphs 5-18 c and d.

5-15/(5-16 blank)