SHELF STORAGE RACK

TM 32-5410-215-14&P

(1) Slide storage cabinet into rack.

(1) Loosen two panel fasteners securing shelf in

(2) Align storage cabinet and rack mounting

closed position.

holes.

(2) Reach under each shelf side and press stops

(3) Secure using four flat washers (2), lock

up.

washers

(3) While holding stops up, pull shelf out about

(14) and screws (15).

one inch.

(4) Close storage cabinet door.

(4) Release stops.

(5) Pull shelf from rack.

b. Installation.

5-14 DRAWER ASSEMBLIES. See figure E-5. The

(1) Align shelf slides and rack slides.

following procedures apply to a 3-1/2-inch or 7-inch

(2) Slide shelf into rack.

drawer storage assembly.

(3) Secure shelf to rack by tightening two panel

fasteners.

a. Removal.

(1) While holding latch to the left, pull drawer

5-17 CABINET SAFE. See figure E-l (sheet 2 of 2).

open until stops engage.

(2) Lift drawer front.

a. Removal.

(3) Pull drawer free of rack.

(1) Open safe door.

(4) Remove right and left drawer slides from

(2) Detach safe (17) from bracket (22) by

rack by removing four screws, eight flat washers, and

removing two screws (20, 21) flat washers (27), nuts (28),

four nuts.

and spacers (25)

b. Installation.

(3) Detach safe (17) from shelter floor by

(1) Align right and left drawer slides with rack

removing four screws (29, 30) lock washers (31), and flat

mounting holes. Secure slides to rack using eight flat

washers (27)

washers, four screws, and four nuts.

(4) Remove safe (17).

(2) Align drawer slides with rack slides.

(5) Remove four spacers (32).

(3) Slide drawer into rack.

b. Installation.

(1) Position four spacers (32) and safe (17) over

5-15 SHELF STORAGE RACK. See figure E-1 (sheet 2

shelter floor mounting holes.

of 2).

(2) Secure safe (17) to floor using two flat

washers (27), lock washers (31), and screws (29, 30).

a. Removal.

(3) Position two spacers (25) between safe (17)

(1) Remove shelves from rack (paragraph 5-

and bracket (22) mounting holes.

16a).

(4) Secure safe (17) to bracket (22) using two flat

(2) Detach rack from upper bracket by

washers (27), screws (20, 21), and nuts (28).

removing two screws (35)lock washers (31), and flat

(5) Close safe door.

washers (27).

(3) Detach rack base plate from shelter floor

5-18 WORK CONSOLE.

by removing four screws (26) lock washers (24), and flat

washers (23)

WARNING

(4) Remove rack.

b. Installation.

(1) Align rack base plate with shelter floor

Dangerous voltage is present in the

mounting holes.

electrical circuits. Death on contact may

(2) Secure base plate to floor using four flat

result. Use all safety precautions and be

washers (23) lock washers (24), and screws (26).

extremely careful when performing

(3) Secure rack to upper bracket using two

electrical troubleshooting and repairs.

flat washers (27) lock washers (31), and screws (35).

(4) Install shelves in rack (paragraph 5-16b).

a. Removal. Item numbers below refer to figure E-1,

sheet 2 of 2, unless otherwise indicated

5-16 SHELF STORAGE RACK SHELVES.

See figure E-6.

a. Removal.

5-11