REASSEMBLY (CONT) - TM-3-4230-209-30-P0203

Position the strap (5) over the rear section of electrical cable clamp (2),

Strap (5)

insert two screws (6) through the strap and into electrical cable clamp (2)

Screw (6)

tapped holes, and tighten.

Lug terminal (7)

Hole (8)

Strip and cut the other end of electrical power cable (1) to the lengths

shown in the illustration. Install two lug terminals (7) on power cable (1) so

its bare wires just protrude through the lug terminal barrel. Using proper

tools, crimp lug terminals (7) to power cable (1).

Using a multimeter set at Xl, zero the meter and measure the resistance

between lug terminal (7) on white wire and the outside of electrical plug

connector (3). The multimeter should read nearly zero ohms. Check from

lug terminal (7) on black wire to electrical plug connector (3) contact pin

with the multimeter. The multimeter should read nearly zero ohms.

Using a multimeter set to highest X setting, zero the meter and measure

the resistance between the electrical plug connector (3) contact pin and

the outer shell. The multimeter should read near infinite resistance.

Using silicone compound, fill electrical plug connector (3) rear section

through the small hole (8) on the side and let it dry.

TM 3-4230-209-30&P

2-187