REASSEMBLY - TM-3-4230-209-30-P0202

2-186

TM 3-4230-209-30&P

2-42. POWER CABLE ASSEMBLY (CONT).

LOCATION/lTEM

ACTION

REMARKS

Power Cable Assembly/

Power cable (1)

Strip power cable (1) to the proper length as shown in the illustrations.

With the screws and strap removed from electrical cable clamp (2), slide it

Electrical cable clamp (2)

back on power cable (1) with the screw holes facing the long part of

power cable (1). Fold the bared end of the black wire back against itself.

Insert the folded black wire into the contact of electrical plug

connector (3), solder the connection, and let it cool.

Carefully bend power cable (1) 90 degrees and lay it in one half of electri-

Electrical plug connector (3)

cal plug connector (3) rear section. Aline the keyway with power cable (1)

Screws (4)

Position the white wire (bared part) against the upper part of electrical

plug connector (3). Then place the second half of electrical plug

connector (3) rear section on top, insert two screws (4), and tighten.

Screw electrical cable clamp (2) onto electrical plug connector (3) and

tighten handtight.