REPAIR - TM-3-4230-209-30-P0201

Strip approximately 3/8 inch of the rubber coating off the black and white

Lug terminals (2)

wires, and insert the wires through two lug terminals (2). Using the proper

tools, crimp two lug terminals (2) onto the two wires.

Using soldering equipment, unsolder the electrical wire (3) from the con-

Electrical wire (3)

nector pin (4) and remove any broken wire strands.

Connector pin (4)

The white wire is held against the inner metal strip and

Strip one inch of the rubber coating off the black wire and bend 1/2 inch of

the outer metal elbow section of the electrical plug

the wire back against itself. Insert the folded black wire into the connector

connector when assembled.

pin (4) and solder.

TM 3-4230-209-30&P

2-185