APPENDIX C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LISTS

TM 10-4930-233-14

TM 4930-14/1

Appendix C

COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LISTS

Section I. INTRODUCTION

C-1. SCOPE

This appendix lists components of end item and basic issue items for the Lubrication and Servicing Unit to help you

inventory items required for safe and efficient operation.

C-2. GENERAL

The Components of End Item and Basic Issue Items Lists are divided into the following sections:

Section II Components of End Item. This listing is for informational purposes only, and is not authority to

requisition replacements. These items are part of the end item, but are removed and separately packaged for

transportation or shipment. As part of the end item, these items must be with the end item whenever it is issued or

transferred between property accounts. Illustrations are furnished to assist you in identifying the items.

Section III. Basic Issue items. These are the minimum essential items required to place the Lubrication and

Servicing Unit in operation, to operate it and to perform emergency repairs. Although shipped separately packaged, Bll

must be with the Lubrication and Servicing Unit during operation and whenever it is transferred between property

accounts. The illustrations will assist you with hard-to-identify items. This manual is your authority to request/requisition

replacement Bll, based on TOE/MTOE authorization of the end item.

C-3. EXPLANATION OF COLUMNS

The following provides an explanation of columns found in the tabular listings:

Column (1) - Illustration Number (Illus Number). This column indicates the number of the illustration in which

the item is shown.

Column (2) - National Stock Number. Indicates the National stock number assigned to the item and will be

used for requisitioning purposes.

Column (3) - Description. Indicates the Federal item name and, if required, a minimum description to

identify and locate the item. The last line for each item indicates the FSCM (in parentheses) followed by the part

number.

Column (6) - Unit of Measure (U/M).

Indicates the measure used in performing the actual

operational/maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in,

pr).

Column (7) - Quantity required (Qty rqr). Indicates the quantity of the item authorized to be used with/on the

equipment.

C-1