Assembly- (cont.)

TM 5-4930-233-14

TM 4930-14/1

LUBE TANK ASSEMBLY

5-19. HIGH PRESSURE PUMP - REPAIR - (Cont.)

Assembly- (cont.)

(21) Install plug (34).

(22) Install gasket (33) and valve seat (32).

(23) Lubricate sides of slide valve (31) that contact valve guide and plug assemblies (29).

(24) Install slide valve (31), two stops (30), two valve guide and plug assemblies (29) and four screws (28).

(25) Coat shuttle (21) (including inside bore), plungers (26) and toggles (27) with lubricant.

(26) Install two toggles (27), two plungers (26) and shuttle (21). Be sure that larger bore of shuttle is facing

upwards.

(27) Install preformed packing (25) and position valve body and stop assembly (24) on five tie rods. Install five

nuts (23).

(28) Lift trip rod as shown and install nut (22).

(29) Install preformed packing (20), adapter (19) and eyebolt (18).

(30) Install spring (17), washer (16) and cylinder (15) into cap (12). Be sure that top of cylinder is flush with or

below edge of cap. Repeat for other cap.

(31) Coat four springs (14) with lubricant.

(32) Install four springs (14), two gaskets (133), two caps (12) and two set screws (11).

(33) Place ounce (7.4 ml) of oil into air cavity before installing preformed packing (10), adapter (9) and four

screws (8).

5-116