Click here to make tpub.com your Home Page

Page Title: RESTARTS AND STARTING PROCEDURE
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

PRESTART AND STARTING PROCEDURE
not released, the engine will turn over but will
1.  For first time starts after machine has been stored
for a period of time, refer to OUT OF STORAGE
not start.
SERVICE.
7.  Place gear lever in neutral position.
8.  Depress throttle pedal.
2.  Check all oil levels according to MAIN- TENANCE
9.  Turn key to START position.
SCHEDULE. Check fuel level.
Caution: Do not crank engine more than 30 seconds
continuously.
3.  Visually inspect machine for leaks or component
10. After engine starts, release throttle pedal and check
damage.
engine oil pressure gauge. If pressure is not indicated
4.  Remove safety links.
within 15 seconds, shut off engine and determine cause.
11.  Depress' throttle pedal to deactivate ammeter
5.  Make certain that no one is in center joint area
warning light.
between scraper bar and rear wheel.
6.  Release handbrake.
Note: The handbrake switch is connected to the fuel
solenoid shut off. If the handbrake is
COLD WEATHER STARTING
The  best  aid  for  cold  weather  starting  is  proper  aid, the use of an ether spray or ether soaked rag may aid
maintenance. Check cooling system anti-freeze protection;  starting.
keep batteries fully charged and properly serviced; and use  Caution: Spray ether only while cranking engine. Do not
an engine oil suitable for anticipated temperatures.
inhale ether fumes.
If machine is fitted with optional cold starting aid, activate
If machine is not fitted with optional cold start- ing
pump while cranking engine.
WARM-UP CHECKS
7. Fuel level gauge
Hold engine at idle speed for approximately two minutes
8. Visually inspect machine for leaks
after starting. Perform the following checks:
9. Lights
1. Engine oil pressure gauge
10. Horn
2. Converter oil pressure gauge
11. Operation of controls
3. Transmission oil temperature gauge
Allow engine to reach operating temperature before
operating machine.
6. Hydraulic oil level gauge
K300
Rev. 760501
200-4.1

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business