Reassembly of Pinion Shaft (CONT)

2. Install inner pinion bearing retaining ring (Fig. 90).

5. Press bearing cups into pinion bearing cage (Fig. 94).

Bearing driver dimensions are shown in Figs. 95 and

96.

3. Press center pinion bearing cone onto pinion shaft (Fig.

91). Bearing driver dimensions are given in Fig. 92..

4. A pinion bearing spacer and shim kit is provided for

service repair of differential and carrier assemblies.

This kit, consisting of a spacer and quantity of shims, is

used to obtain proper pinion bearing preload as

described below. Position bearing spacer and one

.010" shim on pinion shaft (Fig. 93).