Click here to make tpub.com your Home Page

Page Title: Low Clutch Reassembly
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Figure 92
Install one steel disc.
Figure 89
Install clutch shaft oil sealing rings. Grease rings
to facilitate reassembly into front housings.
Low Clutch Reassembly
Figure 93
Install one friction disc. NOTE: The friction discs in the
Figure 90
low clutch has a higher co-efficient rating than the
friction discs in the other clutches, therefore the discs
Install new clutch piston inner and outer sealing ring. Insert
must not be mixed. The low clutch inner disc can be
piston into clutch drum using caution as not to damage
identified by an "X" stamped on one side of the inner
seals. Position piston return spring, spring  retainer and
teeth. The low clutch inner disc also has a strip of non
retainer snap  ring.  Compress spring and retainer and
soluble yellow paint sprayed on the outer edge of the
install snap ring.
disc. Alternate steel and friction discs until the proper
amount of discs are installed. First disc next to the piston is
steel, last disc installed is friction.
Figure 91
Figure 94
Install low gear inner bearing.
Install end plate and retainer ring.
17

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business