 |
|||
|
|
|||
|
Page Title:
INSTALL CRANKSHAFT REAR SEAL WEAR SLEEVE |
|
||
| ||||||||||
|
|
 3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
CRANKSHAFT REAR SEAL WEAR SLEEVE,
FLYWHEEL HOUSING
INSTALL CRANKSHAFT REAR SEAL WEAR
SLEEVE
Tools Needed
A
5P290
Pilot
1
1P5515
Bolt
2
5P286
Ring
1
9S8864
Pusher Plate
1
9S8858
Nut
1
1.
Install tooling (A) as follows:
a)
Install pilot (1) on the end of the
crankshaft. Install .bolts (4) and tighten
enough to hold the pilot (1). Put wear
sleeve on pilot (1) with the outside angle toward
the rear of the engine. Push the sleeve on
the crankshaft to put pilot (1) in the center,
then tighten bolts (4).
b) Put ring (2) on plate (5) and put this
assembly on to the stud of pilot (1). Put on
nut (3) and push the sleeve on to the
crankshaft. Remove tooling (A).
end by:
a) install crankshaft rear seal
b) install flywheel
REMOVE FLYWHEEL HOUSING
11-1157
start by:
a) remove starter
b) remove marine gear (marine engine only)
c) remove flywheel
1.
Loosen the bolts that hold the oil pan to the
cylinder block. Remove the bolts that hold the
oil pan to the flywheel housing. Fasten a hoist
to the rear of the engine. Lift the rear of the
3.
Cut the gasket so it is even with the bottom of
engine and install shims on each side of the
the block and flywheel housing. Remove the
cylinder block.
shims from each side of the block and tighten
2.
Remove the bolts (2) and locks that hold the
the bolts for the oil pan. Install remainder of
flywheel housing in place. Remove flywheel
bolts in oil pan.
housing (1).
4.
Install the starter.
INSTALL FLYWHEEL HOUSING
12-1157
end by:
a) install marine gear (marine engine only)
1.
Clean the contact surfaces of the flywheel
b) install flywheel
housing and cylinder block. Install a new
gasket.
2.
Put oil on the lip of the rear seal. Put flywheel
housing in position and install the locks and
bolts.
91
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals