|
|
3208 INDUSTRIAL AND MARINE ENGINES
DISASSEMBLY AND ASSEMBLY
GOVERNOR
ASSEMBLE GOVERNOR
16-1264
Tools Needed
A
1P529
Handle
1
1P456
Drive Plate
1
1P463
Drive Plate
1
1. Use tooling (A) to install the seal in the
governor housing with the lip of the seal
toward the inside of the housing.
2. Put the lever (2) in position in the governor
housing with a washer (1) between the lever
(2) and the housing at each side.
3. Slide the shaft (3) into position and install
the two bolts that hold the lever (2) to the
shaft (3).
4. Install a race (5), a bearing (6), a race (7),
and a ring (8) on the thrust collar (4).
5. Install the weights (12) on the carrier (11)
with the dowels (13).
6. Install dowel (9) in the shaft (10).
7. Install the shaft (10) in the carrier (11).
end by:
a) connection of governor to fuel injec-
tion pump housing
33
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |