|
|
FUEL SYSTEM
TESTING AND ADJUSTMENT
17. Remove bolts (28). Remove governor shaft (26),
governor lever (27), and Shims (25) from the
governor housing.
COVER INSTALLED
5. Cover.
15. Install spring (6) on shaft (22).
16. Install seat and piston assembly (23) on shaft (22).
GOVERNOR HOUSING
25. Shims (two). 26. Governor shaft. 27. Governor
lever. 28. Bolts,
18. Put governor shaft (26) and governor lever (27) in the
governor housing for the dashpot governor. Be sure
there is a shim (25) on each side of governor lever
(27). Install bolts (28) that hold governor lever (27) to
governor shaft (26).
19. Install springs (4) and seat (3) into governor housing
(29).
NOTE: Be sure both springs are completely on seat (3)
before installing in governor housing (29).
SPRING INSTALLED
6. Spring. 22. shaft,
20. Position governor housing (29) on the pump housing.
Install bolts (1) that hold governor housing (29) on the
NOTE: Turn spring (24) on the piston and seat, Turn
pump housing.
spring (24) until it just contacts the shoulders on the piston
and seat. The piston and seat must be alignment after
spring (24) is installed. If not, remove the spring and
install again.
GOVERNOR HOUSING INSTALLED
1. Bolts. 29. Governor Housing. A, 2P8315 Bracket
Assembly.
21. Remove bracket assembly (A).
SEAT AND PISTON ASSEMBLY INSTALLED
22. Shaft. 23. Seat and piston assembly. 24. Spring.
69
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |